LAZERTOYZ *Lite R/C lighting system.

Transmitter Controlled RC Airplane Navigation Lights, Strobe, and Landing Lights with auxiliary output.

Thank You for purchasing the most advanced and versatile RC navigation light system available. Your Light Screamer will give many hours of operation as long as you read an follow the directions carefully.

Each unit comes ready to install on your model. Just take the servo connector and plug it into and extra channel output on your receiver, if you do not have an extra output you may use a “Y” connector in the rudder channel that you can give it full left and right to get it into the right mode before flight. When you turn the Transmitter and receiver on, toggle your joystick or switch that the Lite system is hooked to and your lights should react. Once you have your LED lights positioned and the connector plugged into the channel you want on the receiver. All you need to do is move the joystick (or switch) from low to high position, it will then change modes of the lights (see chart below). First just the strobe light then toggle the stick and you have your position lights, move again and your landing lights will come on, it will then restart the sequence with the next toggle. .

You may add lights in Parallel to the wires but keep you polarity correct. The wires should be color coded with the darker color negative and lighter color positive Double Check this with the polarity diagram below. The positive connection goes to the long copper connection at the end of the PCB (Printed Circuit Board). You will find your unit equipped with a servo connector that plugs into your receiver. Plug this into an extra output like Rudder or Gear if you have no extra use a “Y” connector and hook it up, Note you must be able to use 100% (sometimes 101%) in both ranges of travel to change modes.

You may attach up to 5 bright LED’s to each of the 5 outputs Only use Lazertoyz.com lights because there are different voltage drops on lads, also only use the same color LED’s on the wire do not mix colors as it will degrade brightness . Red lights go on the left wing and attach to the RED output only add red light to the red output wire. Your green light is mounted on the right wing.

Summary: position 0 (Strobe Only strobe is always on), 1^st toggle Position lights red & green, 2^nd toggle position and landing lights.

The Auxiliary output will trigger when in the high position and off in the low position.

Lite R/C lighting system by Lazertoyz OPERATION
CONTROL ACTION	POSITION LIGHTS	LANDING LIGHT	STROBE LIGHT	Auxiliary	NOTES
				Light
Power On first signal	Off	Off	On Solid	Off
Switch or Joy Low	Off	Off	On Blink	Off	Mode 1
Switch or Joy on or high	On Solid	Off	On Solid	On	Mode 2
High to low change	On Blink	Off	On Blink	Off	Mode 3
Second low to high change	On Solid	On Solid	On Solid	On	Mode 4
High to low change	On Blink	On Solid	On Blink	Off	Mode 5
					Repeats to first signal

You may add lights of the same type and color in parallel to each output connection (+ to + and - to -) with a maximum of 5 LED lights per connection. Exceed this limit at your own risk.

Although our unit will handle many more your BEC may not. Check your ESC & receiver specs for ratings .

The flat on the LED indicates the Negative Polarity side