Lazertoyz Brushless Motors and ESC's

You are Visitor #

Your plane can do this too with the new Lazertoyz V4 light strip controller board!

Makes night flying fun and easy!

just plug your 3 cell battery in and plug into an extra channel on the receiver . then plug your light strips into the controller you can turn them on and off and make them blink the same as our V2 Kit.

V4 Controller Board

$39.00

Schematic Of Light Strip Modification to existing Light Kits

This is how to convert your V2 or V3 light kit to power the light strip with Transmitter control

Do this Mod at your own risk !

Lazertoyz Light Strip (JST and balance connectors not included)

Runs off of 9-13 volts DC ( a 3 cell battery is perfect)
3 cell battery works great-
use a balance connector if you want a disconnect
Super ultra bright LED's
Easy to install
Tape strip on back side
Marked for + and - voltage
Comes in red, green, blue, white, and yellow

2"-6"-12" strips

no connector, you solder your own system together

When you order more than 1 foot of 1 color you will receive an uncut length of that color

You can use the outside connectors of this balance connector to supply power to the strip. I pull the two center pins out to prevent a short . $3.00 for the connector

Light Strips (6" or 12") with pre-soldered JST

Can be used alone with a 3 cell battery or daisy chained in unlimited lengths. Just supply a 3 cell battery with 10-12 volts.

6" for $4.29

12" for $5.99

30 AWG Wire - (equal length of yellow and white) 1.00 per foot (just order as many feet as you like it will be a continuous length) $1.00

3/64 Shrink tube for 30 awg wire $1.00

Female JST connector: $1 (not included with light strip)

How to solder the board: Just put some fresh solder on your solder tip and touch it to the pad on the light strip it will attach in a couple seconds, tin your wire then add your wire ...